Technical article
Complete Discharge and Residual Hold-Up in Mixers
How vessel geometry, valve design, powder flow and downstream transfer determine residual heel and cleanout time.
PerMix North America
Industrial Mixing Knowledge Center
Engineering articles on mixer selection, powder behavior, scale-up, blend uniformity, cleanability, jackets, vacuum and industrial mixing systems.
Proven Global Technology
Built for Demanding Industries
North American Support
Mix
Solve
Create
A Brighter
Tomorrow
Engineering-driven solutions
Industrial Mixing Knowledge Center
Engineering articles on mixer selection, powder behavior, scale-up, blend uniformity, cleanability, jackets, vacuum and industrial mixing systems.
Application Expertise
Solutions selected around the material and process.
Reliable Equipment
Industrial construction designed for production use.
North American Support
Responsive engineering, service and lifecycle coordination.
Global Technology
A broad platform of proven mixing and processing technologies.
Technical article
Industrial Mixer Scale-Up from Pilot to Production
A disciplined scale-up method using material movement, fill range, tool speed, power input and batch-cycle measurements.
Technical article
Information Required for an ATEX Mixer Design
The area classification, material hazard data and operating scenarios needed before selecting hazardous-area mixing equipment.
Technical article
Vacuum Mixing and Drying: Building the Design Basis
The data required to size a vacuum mixer or mixer-dryer, including vapor load, heat sensitivity, filtration and solvent recovery.
Technical article
Sanitary Mixer Design and Cleaning Access
A practical review of surface finish, access doors, seals, discharge geometry, spray devices and cleaning verification.
Technical article
Cohesive Powder Mixing and Deagglomeration
How cohesion, moisture, electrostatics and soft agglomerates influence mixer intensity, chopper selection and batch time.
Technical article
Mixing Fragile Powders and Granules
A selection framework for limiting particle breakage, fines generation, heat and segregation during blending and discharge.
Technical article
Adding Liquids to Powders in Batch Mixers
Nozzle selection, droplet size, spray rate and powder circulation must be engineered together to avoid wet lumps and uneven coating.
Technical article
Bulk Density and Working Volume in Mixer Sizing
Why batch mass, loose bulk density, operating density and usable fill range matter more than gross vessel volume.
Technical article
Ribbon vs. Paddle vs. Plough Mixer Selection
A practical comparison of material movement, shear, liquid addition, particle fragility and deagglomeration capability.
Technical article
Low-Pressure Jackets vs. ASME Mixer Systems
Understand when a standard non-ASME jacket is appropriate and when vacuum, pressure or code-rated service moves to QuantumX.
Technical article
Ribbon Mixer vs. Paddle Mixer: How to Select
Compare agitator geometry, product movement, shear, particle fragility and density variation before selecting a powder mixer.
Get expert advice
Request Engineering Support
Tell us about your application and our mixing experts will help you find the right solution.
A trusted partner for North America
Global Technology.
Local Support.
Global & Experienced
Established mixing platforms
Engineering Solutions
Factory-to-field support
Timely, Local
Dedicated project response